#10MinuteTalk - “Over-Torqued Rings”

If you hunt, shoot or compete with an optics-equipped firearm, this could be the most important information you hear or that you can give to your friends to create the most reliable, accurate and repeatable setup possible. “Over-Torqued Rings” is a phrase we’ve mentioned in the past on the podcast and one you may have heard about on the internet from time to time. There’s all kinds of different rings/mounts/specs/ideas/theories out there that can make actually getting the right information on how to properly tighten the rings around your scope tube difficult. While it’s nearly impossible for us to go through every single ring/mount ever created, Jimmy and Mark give a breakdown on the most common ring/mount types we see and not only how to set them up properly, but also why it’s so important that you do. We also talk about scope position in the rings, why the use of thread locker is unnecessary for your ring screws, and a bunch more…    *Please note* - When Jimmy discussed the torque sequence for vertically split rings, the “Top first, then bottom” is the specific sequence we recommend for our older “Pro” or “Viper” series of rings, which are unique in and of themselves being that they’re not like other vertically split rings like those from Warne, American Defense, LaRue, etc. For some of those rings/mounts, we will actually recommend doing the bottoms first, to around 25 inch pounds, and then the tops to our recommended 15-18 inch pounds. Like we said in the podcast – there are so many ring/mount types, it’s always worth it to give us a call when mounting up your scope with a non-Vortex ring/mount to get a second opinion before diving in!