#234 Was alle 3D-Druck Anwender falsch machen

from 3D-Druck Podcast · host Johannes Lutz

Bevor die Technik des 3D-Druckers ins Spiel kommt, gibt es vorher noch viele Fehler in der Herangehensweise, die Anwender aus Unwissenheit machen. Dabei glaubt man, es sei richtig was man macht, dabei führt es nur zu noch mehr Problemen. Diese Fehler macht Ihnen die Additive Fertigungsbranche vor, obwohl diese zu Misserfolg führen. In dieser Folge geht es darum Misserfolg zu vermeiden, bestimmte Dinge nicht mehr zu machen und anders darüber zu denken. Viel Spaß.

Episode metadata supplied by the publisher feed · Published Jul 3, 2023

Embed this episode

Attribution link and audio player

NOW PLAYING

#234 Was alle 3D-Druck Anwender falsch machen

0:00 15:51

1×

No transcript for this episode yet

We transcribe on demand. Request one and we'll notify you when it's ready — usually under 10 minutes.

Share this episode

Similar Episodes

No similar episodes found.

Similar Podcasts

No similar podcasts found.

Frequently Asked Questions

How long is this episode of 3D-Druck Podcast?

This episode is 15 minutes long.

When was this 3D-Druck Podcast episode published?

This episode was published on July 3, 2023.

Is there a transcript available for this episode?

Yes, a full transcript is available for this episode. You can read the complete transcript on the episode page.

Can I download this 3D-Druck Podcast episode?

Yes. Use the download control on the episode player to save the publisher-provided media file.

URL copied to clipboard!