321 DJI on Remote ID

DJI brings out the guns in its criticism of the Remote ID proposal, the Air Force has new medical standards for RPA pilots, a better communications antenna for UAVs, a draft executive order that would ban Chinese drones from the federal government, and using drones to speed 5G deployment.UAV NewsDJI urges FAA to reconsider Remote ID NPRMThe comment period for the FAA Notice of Proposed Rulemaking (NPRM) for the Remote Identification of Unmanned Aircraft Systems is closed, but not before DJI submitted an 89-page formal comment. The FAA estimated its proposed Remote ID rules would cost about $582 million over the next 10 years. In the report prepared by NERA Economic Consulting, the cost was calculated at $5.6 billion over that period. DJI has demonstrated a direct “drone-to-phone” wi-fi based solution.Medical standards changing for RPA pilotsEffective February 28, 2020, the Air Force changed the medical standards for remotely piloted aircraft pilots. Previously, graduating RPA students had to meet the medical standards designed for aircrew operating at altitude. Now, these Airmen will only need to meet the Ground-Based Operator medical standards.New Antenna Will Boost UAV Communication with SatellitesChinese researchers have developed a compact saber-shaped antenna for UAVs that can switch between two radiation patterns for better communication coverage. The new antenna incorporates a monopole perpendicular to the ground with an omnidirectional pattern and a dipole parallel to the ground with a broadside pattern. Published in a study in IEEE Transactions on Antennas and Propagation.US is preparing to ban foreign-made drones from government useTechCrunch says the Trump administration is preparing to ban federal departments and agencies from buying or using foreign-made drones. This would be accomplished through an executive order that would effectively ban foreign-made drones or drones made with foreign components.Afraid of heights? Drones, AI and digitalization to the rescue!Deployment of 5G communications has some serious obstacles, including the need for many more antennas. Ericsson is using drones to speed the site survey process and build 3D site models that can be used for engineering decisions.AnnouncementThe 14th annual UAS Summit & Expo is scheduled for September 1-2, 2020 at the Alerus Center in Grand Forks North Dakota. The event is produced and organized by UAS Magazine and BBI International.