Audio Overview Chapter 9 Part 1 Introduction_to_Trim_Calculations
from Stability & Trim for the Ship's Officer Hosted by William E. George
STABILITY AND TRIM FOR THE SHIP'S OFFICER, 4th Edition, by William E. George Fundamentals of Trim and Longitudinal Stability Source Material: pages 187–189, 192–193 I. Longitudinal Stability Foundations (Pages 187–188) Longitudinal Stability: The vessel’s resistance to being longitudinally inclined about its transverse axis. Longitudinal Metacenter (ML): Formed by the intersection of lines of force through B before and after a small longitudinal inclination. Stability Scale: Because a ship’s length is significantly greater than its breadth, the Longitudinal Metacentric Height (GML) is enormous compared to transverse GM. Metacentric Radius (BML): Calculated as BML=IL/∇, where IL is the moment of inertia around the transverse axis and ∇ is the volume of displacement. II. Professional Trim Definitions (.Pages 187–189) Trim: The physical difference between the drafts Forward and Aft. Drag: A term used on tankers and in USCG License Exams meaning Trim by the Stern. Even Keel: A condition where the drafts are identical at the Bow and Aft. Change of Trim: The algebraic sum of the initial and final trims. Rule 1: If trims are both by the head or both by the stern, subtract the lesser from the greater. Rule 2: If trims are different, add the two values. III. Trimming Moments and the LCF (Pages 188–189) Trimming Moment: Created whenever a weight is moved longitudinally or is loaded away from the tipping center. Longitudinal Center of Flotation (LCF): The tipping center or fulcrum of the vessel; the center of gravity of the water plane at a specific draft. Calculation: Trimming Moment = Weight × Distance from the LCF. IV. Trimming Constants: MT1 and MTC (Pages 189, 192–193) MT1 (Moment to Change Trim One Inch): The foot-long tons required to change trim by exactly one inch. MTC (Moment to Change Trim One Centimeter): The meter-metric tons required to change trim by exactly one centimeter. Derivation of MT1: Formula is MT1=(GML×Δ)/12L. Empirical "k" Formula: For license examinations: MT1=k×(TPI)2/B, where k is a constant based on the block coefficient (e.g., k=30 for 0.75). V. Technical Figure References Figure 9-1 (Page 188): The geometric relationship of ML,B,G, and the scale of GML. Figure 9-2 (Page 189): Examples for determining Change of Trim. Figure 9-3 (Page 193): The geometric evolution of the MT1 formula. Produced by William E. George and Powered by Google's Become a supporter of this podcast: https://www.spreaker.com/podcast/stability-trim-for-the-ship-s-officer--4180737/support.
Embed this episode
No transcript yet.