Collab Chatter

Welcome to another episode of This Week in Maker News brought to you by The Driverback. This week our host Adrienne Vita is joined by John, Nathanael, Adam and someone new this week, Gary! This week we talk about our current Maker Collab projects as well as past project that were submitted. If you don't know about the Maker Collab, it is a maker competition put on by Christy from @oakhillmillworks and Nick from @statedwoods this time every year. Be sure to check out those pages and give them a follow. They are all extremely talented and so are the makers that are in the competition. Please give the following accounts a follow because each follow helps us spread out a little more and we want to be able to get more and more makers on to give us there different thoughts and ideas! Thanks to everyone who has been following along so far and welcome to those who are new! The Maker's Stoop - @themakerstoop Adrienne - @hickoryhomesteadcreations Adam - @rock_dingo_woodcraft Nathanael - @nathanael_barnes John - @johndiresta Gary - @garebearwoodworks Then next time you find yourself searching for that one bit you need most, stop and head right to thedriverback.com and use our code STOOP to save yourself money off everything on the site! OUR CODE ONLY DOES THIS! Sweet I know! DRIVERBACK consists of four bit cartridges, each with their own storage tray, retractable lanyard and four custom fabricated impact rated bits of your choice. This system allows you to comfortably store up to four of your most used hex bits right where you need them, on your impact driver! Your DRIVERBACK system comes pre-loaded with your selection of four impact rated bits and is designed to fit most any impact driver on the market, regardless of brand. Replacement and additional cartridges of your choice are also available for maximum customization. Simply strap DRIVERBACK to your impact driver according to the included instructions and be prepared to start saving time. Once installed, you simply select the impact bit you require, pull the bit by the lanyard tab from the storage tray, insert the bit in the quick release chuck, and you are "Always Ready For Your Next Screw!"