Seven Sins of 3D Printing
Episode 441 of the WTFFF?! 3D Printing Podcast Volume Three: 3D Print Tips | 3D Print Tools | 3D Start Point podcast, hosted by Tom Hazzard & Tracy Hazzard, titled "Seven Sins of 3D Printing" was published on February 22, 2017 and runs 27 minutes.
February 22, 2017 ·27m · WTFFF?! 3D Printing Podcast Volume Three: 3D Print Tips | 3D Print Tools | 3D Start Point
Episode Description
Today Tom & Tracy run down their list of the top Seven Sins of 3D Printing that are holding it back from truly being Lean Manufacturing. While 3D printing inherently solves a lot of problems with achieving Lean Manufacturing, there are others that are still holding 3D Printing back. What are they? Listen to this episode to check it out!
To send us a message, go to 3dstartpoint.com or wtfffpodcast.com or shoot us a message at [email protected] or on our facebook or twitter! Its absolutely free, so ask away and and don’t forget to subscribe so you can hear more on our regularly scheduled Thursday podcast episodes!
Similar Episodes
No similar episodes found.
Similar Podcasts
No similar podcasts found.