Short #31 - U-Factor and R-Value

What is the difference between r-value and u-factor? Why should we care about the differences? In this short podcast, we'll explain what those differences between the two are and why you should care. R-value and u-factor are actually pretty close to the same thing; they are inverse coefficients of the same phenomenon. R-value is the resistance to heat energy moving through conductance. R-value is not concerned with radiant gains, such as the sun's UV rays passing through a window; the heat gains occur strictly through conduction, molecule-to-molecule, like heat passing from the wall insulation to the actual wall upon contact. In terms of insulation, a higher r-value is desirable, Inversely, we like to see a lower u-factor. The u-value is the coefficient of heat transfer. So, the r-value's resistance to heat acts directly against the heat transfer of the u-factor. You can convert the u-factor to r-value by dividing the u-factor into 1 (1/u-factor). Similarly, you can get your u-factor from your r-value by dividing the r-value into 1 (1/r-value). We use these values in load calculations and plug them into Manual J programs. We figure out our BTUs per hour in an equation where we multiply the square feet by the u-factor and the delta t. So, our insulation plays into equipment sizing. Some products also have a rated u-factor. You also need to average out the u-factors if you use multiple materials. (Note: sometimes, manufacturer u-factor ratings are not entirely accurate.) Learn more about Refrigeration Technologies HERE. If you have an iPhone, subscribe to the podcast HERE, and if you have an Android phone, subscribe HERE.